Regulatory

Radio Astronomy Site Avoidance

The GSatSolar Series complies with FCC CFR 25.213. The customer end-product must comply with the requirements for radio astronomy avoidance. See Globalstar document GS–07–1248 REMOTE TELEMETRY SERVICE FREQUENCY PLAN FOR SIMPLEX TRANSMITTERS for more details.

Regulatory Notices

The GSatSolar Series has received Federal Communications Commission authorization under FCC Rules Part 25 and Part 15C as a modular transmitter. Final installation must be in compliance with 25.213 (see above). The installation and operating configurations of this transmitter must satisfy the MPE categorical exclusion requirements of 2.1091. The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operated in conjunction with any other antenna or transmitter.

The GSatSolar Series transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant.

The GSatSolar Series module has been labeled with its FCC ID numbers as follows:

Contains Transmitter Module FCC ID: L2V-ST100 IC: 3989AST100 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Additional Notices

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

**ISED is an acronym for Innovation, Science, and Economic Development (Canada).

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de classe B est conforme à la norme NMB-003.

Hereby, Global Satellite Engineering declares that this GSatSolar is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The declaration of conformity may be consulted at www.Globalstar.com/Regulatory.

AVIS: Cet équipement est conforme aux RSS-102 Limites d'exposition RF. Un minimum de 20 centimètres (8 pouces) entre l'appareil et l'utilisateur et toutes les autres personnes devrait être maintenue.

Transmit Frequencies: 1611.25 Mhz - 1618.75 Mhz (4 Channels) Max Power Out: 25.82 dBm EIRP

FCC ID: L2V-ST100 CAN ICES-3(B)/NMB-3B IC: 3989A-ST100 Complies with FCC standards. FOR HOME OR OFFICE USE

The GSatSolar Series has been so constructed that the product complies with the requirement of Article 10(2) as it can be operated in at least one Member State as examined, and the product is compliant with Article 10(10) as it has no restrictions on being put into service in all of the EU except Ireland. The GSatSolar Series cannot be marketed in Ireland.